![\"\"](\"http:\/\/www.electricmotorsales.com.au\/v2\/wp-content\/uploads\/2017\/10\/bore1.jpg\")
<\/td>\n
\nBasic Design Features:
\n
- Pump sizes - 150mm \/ 200mm \/ 250mm.<\/li>
\n - Submersible Motor Drive Unit - 5.5 to 185 kW.<\/li>
\n - Pump Shaft - AS2837-316 Stainless Steel.<\/li>
\n - Bearing\/Stage Rubbers - Styrene Butadiene Rubber 80 - 85.<\/li>
\n - Durometer hardness.<\/li>
\n - Pump Column Top End Piece\/Pump Stages\/Check Valve - Zinc Free Bronze.<\/li>
\n - Impellers - Zinc Free Bronze.<\/li>
\n - Impeller Taper Locks: AS 2837-316 Stainless Steel (self locking).<\/li>
\n<\/ul>
\n> Request more information<\/a>.<\/td>\n<\/tr>\n\n\t ![\"\"](\"http:\/\/www.electricmotorsales.com.au\/v2\/wp-content\/uploads\/2017\/10\/bore2.jpg\")
<\/td>Hiflow Submersible Bore Pumps<\/strong>
\n
\nImpellers are moulded from polycarbonate and reinforced with glass fibre to ensure smooth water passage for minimum friction loss, and at the same time provide resistance to abrasive materials.
\n
\nWith between 7 and 23 stages, they have been expertly matched to the power output of the recommended motors.
\n
\nFor high-yielding bores, the best available pump is the Sta-Rite HighFlow.
\n
\n> Request more information<\/a>.<\/td>\n<\/tr>\n\n\t ![\"\"](\"http:\/\/www.electricmotorsales.com.au\/v2\/wp-content\/uploads\/2017\/10\/bore3.jpg\")
<\/td>Signature 2000 Borehole Pumps<\/strong>
\n
\nThe impeller stack is of a floating design, so that individual impellers can move vertically to allow small solids to pass through, rather than locking up the pump.
\n
\nImpeller bearings use a ceramic material to grind down sand or other particles that are trapped in the pump, allowing them to pass through.
\n
\nThe pump is far less susceptible to clogging up and locking, meaning that Sta-Rite Signature 2000 keeps delivering water long after other pumps have given up.
\n
\n> Request more information<\/a>.<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n\n","protected":false},"excerpt":{"rendered":"
\n